Sinotimer Mc101 Manual < Android PRO >

Overview

• Specific functions you need explained
• Your application (e.g., controlling a pump, light, motor)
• Any settings or symbols you don’t understand

3. The relay clicks immediately but nothing happens.

• Cause: You are wired to NC (Terminals 5 & 7) instead of NO (5 & 6).
• Fix: Move your load wires from terminal 7 to terminal 6.

Mounting: Insert the controller through the panel cutout and secure it from the rear using the provided mounting frame. 2. Wiring Diagram sinotimer mc101 manual

Press and hold SET or MODE for 3 seconds to return to the main display. 4. Safety & Best Practices Overview

Heating vs. Cooling: Access parameter C10. Use 'Da' for heating mode (power applies when PV < SV) and 'Re' for cooling mode (power applies when PV > SV). Autotuning: This feature allows the Specific functions you need explained Your application (e

2. Terminal Layout and Wiring Diagram This is the most stared-at page during setup. The MC101’s eight terminals are numbered 1-8 in clear diagrams: