Rohs 721 Cutting Plotter Driver Pc May 2026

(often branded under JinKa, Goldcut, or USCutter as the MH-721) typically uses a CH340 USB-to-Serial chip

Installation Steps (quick)

  1. Download or insert driver package.
  2. Run Setup.exe as Administrator.
  3. Connect ROHS 721 via USB when prompted.
  4. Let Windows install driver; restart if requested.
  5. Open ROHS Control Panel, run test cut, and calibrate blade/force.

Method B: Manual Driver Installation (if auto-installer fails)

  1. Extract the downloaded driver ZIP file to a folder (e.g., C:\Rohs721_Driver).
  2. Open Device Manager (Right-click Start → Device Manager).
  3. Look for Unknown Device or Other Devices with a yellow exclamation mark.
  4. Right-click it → Update driver → Browse my computer for drivers.
  5. Navigate to the extracted driver folder.
  6. Check "Include subfolders" → Click Next.
  7. Windows will show a warning about an unsigned driver. Select "Install this driver software anyway".
  8. Wait for "Windows has successfully updated your drivers."

I am looking for the correct PC driver for a Rohs 721 cutting plotter. My operating system is [Windows 10 / Windows 11 / etc.]. Rohs 721 Cutting Plotter Driver Pc

Power Cycle: If the PC stops recognizing the plotter, unplug the USB, wait 5 seconds, and plug it back in (preferably into a rear USB port on desktops for better power stability). 4. Basic Operation How to Add Printer Driver in JK721 Cutting Plotter (often branded under JinKa, Goldcut, or USCutter as

Do not download from:

For the software to "see" the plotter, the port settings must be specific: Download or insert driver package