Pramac Ac03 Manual 2021 Site

Technical Paper: Operation and Management of the Pramac AC03 Generator Controller

• Place the generator on level ground.
• Remove the oil dipstick/filler cap.
• Check that the oil level is between the upper and lower marks. If low, top up with SAE 10W-30 or 15W-40 oil (refer to your engine manual for viscosity based on ambient temperature).

• Before starting the generator, ensure the output switch is in the "OFF" position.
• Prime the engine by pumping the fuel primer 3-4 times.
• Start the engine using the recoil starter or electric start.
• Once the generator is running, switch the output to the "ON" position.

3. The "AVR" Reset Button

Does your AC03 have power at the socket but the light won't turn on? You blew the overload. The manual shows you the exact location of the AC Reset button (usually a small black or red protrusion near the 230V sockets). You can't find it by guessing—you need the diagram. pramac ac03 manual

mode. They initiate the engine's start sequence or stop the generator set. Fault Reset : Used to acknowledge active alarms and silence the horn. Technical Paper: Operation and Management of the Pramac

Starts the engine immediately under controlled conditions to verify system health without necessarily transferring the building load. Installation and Wiring Procedures Place the generator on level ground

You can toggle between different functional states using the physical MODE buttons on the interface:

8. Conclusion