Charger 111568 Manual - Motomaster Battery

Transformer-Based Reliability: Unlike newer, lighter switch-mode chargers, this model uses a time-tested transformer design that delivers a constant rate of charge throughout the cycle. Operational Highlights from the Manual MotoMaster Intelligent Battery Charger reviewed by Jesús motomaster battery charger 111568 manual

Placement: Never place the charger directly on top of or below the battery. Keep it as far away as the cables allow to prevent corrosion from battery fumes. Clean clamps with baking soda/water solution to remove

6. Maintenance & Storage

• Clean clamps with baking soda/water solution to remove corrosion.
• Store indoors – never expose to rain or snow.
• Check cords for cracks before each use.
• Do not pull by cord – use the handle.

Q2: How long does it take to charge a completely dead car battery on 10A mode?

A: A typical 50Ah battery will take 5-6 hours. However, if voltage is below 5V, the charger may refuse to start (see troubleshooting above). if voltage is below 5V

Need the Original PDF?

If you require the specific printed schematic or part list, your best resource is to contact Canadian Tire directly or search for generic manuals for similar MotoMaster Eliminator chargers, as the internal circuitry is standard.

Explosive Gases: Batteries generate hydrogen gas. Always charge in a well-ventilated area .