Minipro | 6.85

Version 6.85 was released around October 2018 as the concluding update for the older generation of TL866 programmers (TL866A and TL866CS) before they were phased out in favor of the newer TL866II Plus.

Real-World User Reviews (Compiled from Reddit and Amazon)

• "Perfect first printer" (5/5): "I have never owned a 3D printer before. The MiniPro 6.85 took 15 minutes to set up. My first Benchy looked perfect. No tinkering needed."
• "TPU monster" (4.5/5): "My Ender 3 could never print TPU without jamming. This thing eats NinjaFlex for breakfast. Only complaint is the tiny SD card slot location."
• "Great, but check the ribbon" (3.5/5): "My unit arrived with a loose ribbon cable. Once I reseated it, perfect prints. Customer service responded within 24 hours."

But is the Minipro 6.85 a legitimate game-changer, or just another overhyped clone programmer? This article provides a deep dive into its hardware, software compatibility, real-world performance, and how it stacks up against the competition. minipro 6.85

4. Technical Implications

| Feature | Firmware 6.85 | Firmware ≥6.86 | |----------------------|----------------|----------------| | CS → A upgrade | ✅ Unofficial | ❌ Blocked | | Open-source minipro | ✅ Full support | ⚠️ Partial / broken | | Custom voltage levels | ✅ Allowed | ❌ Locked to preset | | Vpp control | ✅ Direct | ❌ Signed only | | Chip ID override | ✅ Possible | ❌ Rejected | Version 6