Lishui Controller Programming __full__ 〈Deluxe | 2024〉
Lishui Controller Programming: A Comprehensive Guide
Conclusion
Checklist before programming:
- Data: 2 bytes (speed value, 0-100%)
- Example: 0x55 0xAA 0x01 0x00 0x64 (set speed to 100%)
Common Lishui Problems & Fixes
| Symptom | Likely Cause | Programming Fix | |---------|--------------|------------------| | Motor stutters at start | Wrong hall angle | Not adjustable – replace controller | | Weak acceleration | Current limit too low (P12) | Increase P12 by 5A max | | Overly strong regen | Regen level = 5 or 4 | Set P14 to 2 (smooth street) | | Speed limited to 25 km/h | Speed limit (P08) set to 50% | Raise to 100% | | Battery cuts off at half charge | LVC too high (overprotective) | Lower LVC by 2V only (e.g., 42V → 40V for 48V system) | lishui controller programming
Access: On many models, holding the Up and Down arrows simultaneously enters the settings mode. Data: 2 bytes (speed value, 0-100%) Example: 0x55
For minor adjustments like speed limits or wheel size, you can sometimes use the LCD display. Common Lishui Problems & Fixes | Symptom |
- Connect programming cable while controller is wet.
- Flash firmware from unknown sources (brick risk is real).
- Exceed MOSFET rating (usually printed on the board – e.g.,
HY1707= 80V, 80A peak).
