Hyt — Tc-500 Programming Software

Programming your HYT TC-500 allows you to customize up to 16 memory channels with specific frequencies and signaling settings. To get started, you will need the correct Customer Programming Software (CPS) and a compatible PC26 programming cable. 🛠️ Hardware Requirements

Programming requires a bridge between your PC and the radio's 2-pin accessory port. Hyt Tc-500 Programming Software

Squelch and VOX: Adjusting sensitivity settings to filter out background noise or enable hands-free operation. Programming your HYT TC-500 allows you to customize

: Configure CTCSS (38 codes) and CDCSS (83 codes) to eliminate interference and set up distinct workgroups. Operational Parameters RX Frequency: Input receive frequency (e

• RX Frequency: Input receive frequency (e.g., 462.5625).
• TX Frequency: Input transmit frequency (same for simplex, different for repeater).
• QT/DQT Encode/Decode: CTCSS (e.g., 67.0 Hz) or DCS. Leave blank for carrier squelch.
• TX Power: High (5W) or Low (1W).
• Busy Lock: Off (unless you want TX inhibit when channel is busy).

Write Radio: Once finished, click "Write" (or Programming -> Write Frequency) to save the new configuration to the radio.