Hager Controls Bp 10140 Manual [repack]

Hager BP 10140 is not a specific device model but rather the postal box address for Hager Controls S.A.S.

Quick Start / User Guide – Hager BP10140 (General)

1. Key Specifications (Typical)

• Power supply: 24V AC/DC or 230V AC (verify on unit)
• Inputs: 10 digital inputs (e.g., switches, sensors)
• Outputs: Up to 140 control points (relays, triacs) via expansion modules
• Programming: Via Hager ArTu or Logic Pro software (older models may use SF6 or ESY software)
• Communication: RS485 / Modbus RTU (some versions)

Always disconnect power before installing or maintaining any electrical distribution equipment. hager controls bp 10140 manual

The real magic happened at dusk. Using the Scene Function described on page 12, Arthur had programmed the "Evening Glow". As the sun dipped, the Hager controller would command the window blinds to descend—not all at once, but with a precise slat position control that allowed exactly three inches of moonlight to spill onto the lobby floor. Hager BP 10140 is not a specific device

Technical Specifications

What is the Hager BP 10140?

First, it is important to clarify what the BP 10140 typically refers to within the Hager product ecosystem. Hager is renowned for its distribution boards, circuit protection (MCBs, RCDs), and building automation components. Power supply: 24V AC/DC or 230V AC (verify

💡 Pro Wiring Tip: If the label is worn, look for the common (C) and normally open (NO) terminals. For most standard "start" or "access" signals, you will wire between C and NO.