Evenheat Kiln Model 5320 Manual [ SAFE ✦ ]

Essential Guide to the Evenheat Kiln Model 5320 Evenheat Model 5320

Programming a Two-Segment Glass Slumping Cycle

1. Power on the kiln. The display will show current temperature.
2. Tap the center to enter Program Mode.
3. Use the + or - to select an empty program slot (e.g., Program 1). Tap to confirm.
4. Segment 1: Set Ramp (e.g., 400), set Target Temp (e.g., 1300), set Hold (0). Tap next.
5. Segment 2: Set Ramp (99 = high fire), set Target Temp (960 – annealing soak), set Hold (1.0 hour).
6. Segment 3: Set Ramp (200), set Target Temp (750), set Hold (0). Tap next until you see "End."
7. Press and hold Run (right arrow) for 3 seconds.

How to obtain the official manual (recommended steps)

1. Check Evenheat / Paragon official website manuals/downloads by searching site for model 5320.
2. Search web for "Evenheat 5320 manual pdf", "Evenheat kiln model 5320 manual", or "Evenheat 5320 owner's manual".
3. Contact Evenheat/Paragon customer support or authorized dealer with the model and serial number.
4. Look on ceramics forums or user communities (e.g., Ceramic Arts Network, pottery forums) where owners share manuals.
5. Check online auction/listing pages (e.g., eBay) where sellers sometimes include manuals in listings.

• Err1: Usually indicates the thermocouple failed or the temperature is rising too slowly. Check for failed elements or a bad thermocouple.
• ErrP: Power failure. The kiln lost power during the firing.

Initial Ramp: Set all switches to "Low" for the first 2 hours to drive out moisture. evenheat kiln model 5320 manual