Epson Tx300f Bx300f Service Adjustment Program [cracked] (WORKING)

The Epson TX300F / BX300F Service Adjustment Program is a technician-level software utility designed to perform hardware-level maintenance and resets that are not available through standard printer drivers. Key Functions & Features

Step 1: Prepare Your Printer

  1. Turn off the printer.
  2. Connect it directly via USB (no hubs, no network).
  3. Make sure no paper is jammed, and the ink cartridges are installed.
  4. Physically address the waste ink pads – either replace them or clean and dry them thoroughly. Do not skip this if you are resetting the counter.
  1. Unplug the printer.
  2. Remove the scanner unit (varies by model, usually 2-4 screws under the document feeder).
  3. Locate the white absorbent pads in the bottom right or back left corner.
  4. Wear gloves. Remove the soaked pads. Squeeze out ink under running water.
  5. Let them dry for 24 hours OR replace with new pad material (or even kitchen paper towel in a pinch).
  6. Reassemble the printer.
  1. Turn off your printer. Disconnect it from the internet/power for a second, then plug it back in (leave power OFF).
  2. Install the driver. You need the standard Epson driver installed first so Windows recognizes the printer.
  3. Disable your Antivirus (Temporarily). These programs are often flagged as “hack tools.” They aren’t viruses, but they manipulate system files. Turn AV off just for the download/unzip.
  4. Run the program. Right-click AdjProg.exe > Run as Administrator.
  5. Select your model. In the dropdown, choose Stylus TX300F or BX300F.
  6. Connect. Turn the printer ON. Click the “USB Auto Selection” button. It should find your printer ID.
  7. The Menu. Click “Particular adjustment mode”.
  8. Select “Waste ink pad counter” from the list.
  9. Click “Check” to see the current percentage. (It will likely say 100% or 200%).
  10. Click “Initialization” . A box will pop up asking which counter to reset (Main and/or Platen). Check both.
  11. Click “OK” . Wait 5 seconds.
  12. Turn the printer OFF. Wait 10 seconds. Turn it back ON.

Benefits of Using the Epson TX300F BX300F Service Adjustment Program epson tx300f bx300f service adjustment program

Every Epson TX300F and BX300F printer is equipped with internal waste ink pads—absorbers designed to collect excess ink during head cleanings and initial charges. To prevent these pads from overflowing and damaging the printer or its surroundings, the printer's firmware uses a counter to estimate when they are full. The Epson TX300F / BX300F Service Adjustment Program

The printer works fine mechanically. The heads are clean. The ink is full. But your printer has decided to stop working, flashing an error about a “Service Required” or a “Parts End of Life” message. Note: Windows 11 may require running the program