Cobra 3195 Alarm Manual Full =link= Site

1. Quick‑Start Summary

| Step | Action | Details | |------|--------|---------| | 1 | Power the Unit | Connect the power adapter (12 V DC, 1 A) to the rear power jack. The unit will power up within a few seconds and the LCD will show “‑‑‑”. | | 2 | Set the Date & Time | Press MENU → SETUP → TIME/DATE. Use the ▲/▼ keys to adjust, ENTER to confirm. | | 3 | Select the Alarm Mode | Press MODE until you see OFF / HOME / AWAY on the display. Each mode has a different sensor sensitivity (see “Alarm Modes” below). | | 4 | Arm the System | Press ARM. The LCD will flash “ARMING” for 30 s (you can adjust the delay in the menu). After the countdown the display shows the selected mode (HOME or AWAY). | | 5 | Disarm | Enter your 4‑digit PIN on the keypad and press ENTER. The system returns to OFF. | | 6 | Test Sensors | From the main screen press TEST → choose a zone → ENTER. The sensor will beep and the LCD will indicate “OK” or “FAIL”. |

Sensor Exclusion: To leave a pet or person inside, press Button B within 20 seconds of arming to temporarily disable the internal ultrasonic sensors. Emergency PIN Override cobra 3195 alarm manual full

Conclusion: The Cobra 3195 alarm manual provides comprehensive instructions and features for the Cobra 3195 alarm system. By following this guide, you'll be able to install, program, and operate your alarm system with ease. Remember to refer to the manual for specific instructions and troubleshooting tips. (Passive Luxury Information Protocol) interface alarm

9. Where to Find the Full Manual

1. (Passive Luxury Information Protocol) interface alarm. It integrates with your car's existing central locking system to arm and disarm when you lock or unlock the doors. Standard Operation you typically follow these steps:

   If the alarm is triggered, the dashboard LED will flash in a specific sequence to identify the source of the breach: 3 Flashes: Ultrasonic sensor trigger. 4 Flashes: Attempted hotwire/ignition trigger. 5 Flashes: Boot or bonnet circuit issue. Remote Programming To sync a new key fob, you typically follow these steps: