Hardware Information Does Not Match With Your Dongle Best Fix | Autodata 345 The

The error "Hardware information does not match with your dongle" in Autodata 3.45 typically occurs when the Emulator is not correctly linked to your specific computer's Hardware ID (UID) or if the Sentinel Protection Drivers are misconfigured.  Quick Fix Checklist 

Potential Causes

1. If it’s already running (red light), stop it and then start it again until the light turns green.  4. Enable Test Mode (Windows 10/11 only)  The error "Hardware information does not match with

   Open Control Panel > Region and set the format to English (United States) if you still encounter errors. If it’s already running (red light), stop it

   The most common fix is to re-run the "GetUid" utility (GetUid-x86 or GetUid-x64) as an Administrator Uninstall Autodata 345 and dongle drivers

   1. Uninstall Autodata 345 and dongle drivers.
   2. Reinstall the software and drivers from the manufacturer's website.
   3. Configure the dongle and Autodata 345 settings as per the manufacturer's instructions.

   4. Recommended Solutions

   The solutions are listed in order of effectiveness.

   If you are using an authorized version with a license generator, the software needs your specific hardware footprint. Navigate to your Autodata installation folder. Find a tool usually named GetID.exe or License86.exe. Run it as Administrator.

   The Dongle (Hardware Key):
   Autodata 3.45 typically uses a Sentinel HASP (or SafeNet) dongle. Inside the dongle is a unique encrypted "seed" or ID number. The software reads this ID during startup.