Skip to main content

Anycubic Chiron Firmware 1.3.5 Download [updated] < Must Read >

Anycubic Chiron Firmware 1.3.5 is a support-provided maintenance update designed to fix critical operational issues and enable compatibility with updated TFT screens. While often necessary for restoring functionality, user reports indicate potential risks, including Z-axis homing failures and inconsistent bed leveling. For guidance on downloading and installing the software, you can watch this YouTube video.

  • [ ] Downloaded the correct .bin file for your board (Trig 1.4 or 1.3).
  • [ ] Formatted a high-quality microSD card to FAT32.
  • [ ] Flashed the firmware and removed the SD card.
  • [ ] Performed factory reset and full recalibration.
  • [ ] Ran a test print (e.g., a 100mm XYZ calibration cube).

Direct File Info (for verification):

2. Auto-Leveling (25-Point Mesh)

  • Run Prepare > Auto Level. The printer will probe 25 points.
  • Wait for the mesh to complete. The new firmware now saves this mesh automatically.

Anycubic’s Official Support Center
Go to support.anycubic.com, search “Chiron firmware,” and look for archived versions. As of 2025, 1.3.5 may be listed under “Legacy Firmware.” Anycubic Chiron Firmware 1.3.5 Download

If you want, I can:

Anycubic Chiron Firmware 1.3.5 brings significant improvements to the 3D printing experience. By following the steps outlined above, you can easily download and install the latest firmware, ensuring optimal performance and new features for your Chiron 3D printer. Anycubic Chiron Firmware 1