Below is a comprehensive, step-by-step guide covering what “alcor+mp+200717+install” likely refers to, how to safely locate the right package/files, prepare your environment, perform the installation, troubleshoot common issues, and verify the install. I assume this is a software package or firmware build (common naming: project/component_date_action), and will cover both Linux and Windows installation scenarios plus firmware/embedded device steps. If you intended a different target (e.g., a specific device model or a binary from a vendor), say so and I’ll adapt.
| Problem | Solution | |---------|----------| | Driver installation fails – “The hash for the file is not present” | Reboot with driver signature enforcement disabled (see above). | | Device shows “Code 10” (cannot start) | Uninstall device in Device Manager, unplug reader, reboot, reinstall driver 200717 fresh. | | Card not detected | Clean card contacts; test card in another reader. Install Microsoft’s Smart Card Plug and Play updates. | | Conflict with other readers | Disable other smart card readers (right-click → Disable device) in Device Manager. | alcor+mp+200717+install
Identify Your Controller: Use a tool like ChipGenius to verify that your flash drive actually uses an Alcor Micro controller. Uninstall old drivers – Conflicting smart card drivers (e
| Problem | Likely cause | Solution |
|---------|--------------|----------|
| Drive not detected | Wrong driver | Reinstall Alcor driver, disable antivirus |
| Format fails at 99% | Bad NAND blocks | Lower capacity in [Device] → MaxCapacityMB=512 |
| “Device removed” error | Loose USB connection | Use rear USB port, short cable |
| Windows still sees old partition | MBR not updated | Run diskpart clean after AlcorMP finishes |
| Tool crashes on Win10 | 32-bit driver incompatible | Use Windows XP VM (VirtualBox + USB passthrough) | prepare your environment
Controller Support: Optimized for AU6989SN-GT/GTA/GTB/GTC and AU6998 series.